Cisco Training
In all our fictional swap now has three new broadcast domains, by populating all of our switchports with hosts it might have the impact of securing the visibility of host on one broadcast space from seeing hosts on one of the different broadcast domains from a safety stand level that's best and from a affectivity standpoint it achieves exactly what we want
Commsupport Networks offers you with low value high quality Cisco CCNA training within the uk in a classroom or dwell on-line web based environment.
Warning: Purely CD or DVD ROM training needs to be prevented, Studying by watching tv isn't ideal.
Joe is a senior lecturer at Commsupport networks throughout the United Kingdom. Joe teaches Cisco CCNA, CCNP, CCVP courses when he is not out on the highway fixing and building networks, in the event you wish to find out additional about what we do at Commsupport.
Commsupport runs free at some point training periods and free on-line webinars, CCNA training
We're going to use and example 24 port change to see how one can configure the device.
In this exercise the responsibility is to create 3 extra vlans and place eight ports into each vlan, the consequence have to be that the swap has 3 new broadcast domain.
Switch
Switchconfigure terminal
Switch(config)vlan 2
Switch(config-vlan)exit
Change(config)vlan 3
Change(config-vlan)exit
Switch(config)vlan 4
Swap(config-vlan)exit
In the instance above the commands used created and additional 3 vlans on our switch
Switch(config)interface range fastethernet 0/1 - 8
Swap(config-if-vary)switchport mode access
Change(config-if-differ)switchport entry vlan 2
Switch(config-if-range)exit
Switch(config)interface range fastethernet 0/9 - 16
Switch(config-if-range)switchport mode access
Switch(config-if-range)switchport entry vlan 3
Switch(config-if-range)exit
Switch(config)interface range fastethernet 0/17 - 24
Switch(config-if-range)switchport mode access
Switch(config-if-vary)switchport access vlan 4
In the commands above:
The ports numbered from 1 by eight have been assigned to v2
The ports numbered from 9 by means of sixteen have been assigned to v3
The ports numbered from 17 by 24 had been assigned to v4
Swap(config-if-vary)end
Switchcopy run start
Finally we save our configuration.